Smart Accessories & DIY

How to Use Snap Ring Circlip Pliers for Engine and Gearbox Repairs A circlip (or snap ring) is a small metal ring clip that sits inside a groove on shafts or inside bores to lock gears, bearings, and pins in place. Attempting to remove these clips using screwdrivers or regular pliers is dangerous and can

How to Adjust Motorcycle Idling (RPM) on Suzuki, Yamaha, and Bajaj BS6 Bikes On older carbureted motorcycles, adjusting the idle speed (RPM) was as simple as turning a small screw on the side of the carburetor. However, on BS6 fuel-injected bikes, the idle speed is controlled electronically by the ECU via an Idle Air Control

How to Use a Brake Bleeding Kit for Hydraulic Motorcycle Brakes Over time, motorcycle brake fluid absorbs moisture and accumulates air bubbles, leading to a spongy brake lever feeling and reduced stopping power. Bleeding your brakes removes these air bubbles. Using a Manual Brake Bleeding Kit makes this job clean, fast, and easy for a

How to Install a Side Stand Sensor Bypass / Dummy Sensor Modern BS6 motorcycles feature a side stand engine cut-off sensor. While this is a great safety feature, these sensors are located near the ground where they are constantly exposed to water, mud, and dust. When the sensor fails, the ECU thinks the stand is